STOP LIGHT SWITCH INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER


    1. Install the stop light switch mounting adjuster to the pedal support.

  2. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A00K0YLE09
      Text in Illustration
      *1 Brake Pedal
      *2 Adjuster
      *3 Stop Light Switch

      Install the stop light switch to the adjuster until the switch body slightly touches the brake pedal.

      Note

      Do not depress the brake pedal.

    2. A00JXKPE23
      Text in Illustration
      *1 Shaft
      *2 1.5 to 2.5 mm (0.0590 to 0.0984 in.)
      *3 Stop Light Switch

      Rotate the stop light switch counterclockwise so that the clearance is between 1.5 and 2.5 mm (0.0590 to 0.0984 in.) as shown in the illustration.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Note

      Do not depress the brake pedal.

    3. Check the stop light switch clearance.

      Stop light switch clearance
      1.5 to 2.5 mm (0.0590 to 0.0984 in.)

    4. Connect the connector to the stop light switch.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. for LHD:


      1. Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.

      2. Install the screw.

    2. for RHD:


      1. Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.

      2. Install the screw.