FRONT PASSENGER SEAT BELT WARNING LIGHT REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

    A00OBDVE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the No. 2 instrument panel finish panel cushion.

    2. Using a moulding remover, detach the 5 clips and remove the No. 2 instrument panel finish panel cushion.

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    A00OAX0

    1. Detach the 4 clips.

    2. Disconnect the connector and remove the instrument panel finish panel end.

  4. REMOVE TELLTALE LIGHT ASSEMBLY

    A00JZMS

    1. Remove the 2 screws and light.