SEAT HEATER SWITCH INSPECTION


  1. INSPECT SEAT HEATER SWITCH LH

    A0095VXE01
    Text in Illustration
    *a

    Component without harness connected

    (Seat Heater Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (SW) - 7 (RV) Switch off 2.7 to 4.1 kΩ
      Switch on (Min.)
      Switch on (Max.) 0.28 to 0.42 kΩ

      Tech Tips

      As the dial is being turned, the resistance changes gradually.

      If the result is not as specified, replace the seat heater switch.

    2. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 8 (ILL+)

      Battery negative (-) → 2 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the seat heater switch.

    3. Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.

      OK
      Measurement Condition Switch Condition Specified Condition

      Battery positive (+) → 9 (IG)

      Battery negative (-) → 4 (E)

      		 Switch on Indicator illuminates

      If the result is not as specified, replace the seat heater switch.

  2. INSPECT SEAT HEATER SWITCH RH

    A0099ASE01
    Text in Illustration
    *a

    Component without harness connected

    (Seat Heater Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (SW) - 5 (RV) Switch off 2.7 to 4.1 kΩ
      Switch on (Min.)
      Switch on (Max.) 0.28 to 0.42 kΩ

      Tech Tips

      As the dial is being turned, the resistance changes gradually.

      If the result is not as specified, replace the seat heater switch.

    2. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 6 (ILL+)

      Battery negative (-) → 1 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the seat heater switch.

    3. Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.

      OK
      Measurement Condition Switch Condition Specified Condition

      Battery positive (+) → 7 (IG)

      Battery negative (-) → 3 (E)

      		 Switch on Indicator illuminates

      If the result is not as specified, replace the seat heater switch.