LUMBAR SWITCH (for Power Seat) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE FRONT SEAT ASSEMBLY


    1. Remove the front seat assembly Click here.

  2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    A00XDO4

    1. Using a moulding remover, detach the 2 claws and remove the knob.

  3. REMOVE RECLINING POWER SEAT SWITCH KNOB

    A00XHAC

    1. Using a moulding remover, detach the 2 claws and remove the knob.

  4. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. Disconnect the lifter motor connector.

    2. Remove the screw of the front seat No. 1 inner cushion shield and detach the guide.

    3. Detach the clip of the front seat No. 1 inner cushion shield.

    4. Using a moulding remover, detach the 3 claws and guide.

    5. Move the cushion shield in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield together with the cushion shield as a unit.

      A00XI83
    6. A00XJLJ

      Detach the 3 claws and open the wire harness cover.

    7. Detach the 3 wire harness clamps and disconnect the seat wire connector.

  5. REMOVE FRONT POWER SEAT SWITCH LH


    1. Remove the 3 screws.

    2. A00XFDW

      w/ Seat Memory System:

      Disconnect the 2 power seat switch connectors and remove the switch.

    3. A00XGWO

      w/o Seat Memory System:

      Disconnect the power seat switch connector and remove the switch.

  6. REMOVE LUMBAR SWITCH ASSEMBLY

    A009AX6

    1. Using a screwdriver, detach the 2 claws.

    2. Disconnect the lumbar switch connector and remove the lumbar switch.