LUMBAR SWITCH (for Manual Seat) REMOVAL

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE FRONT SEAT ASSEMBLY


    1. Remove the front seat assembly Click here.

  2. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    A00XESUE01
    Text in Illustration
    *1 Protective Tape

    1. Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the handle.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE VERTICAL ADJUSTING HANDLE LH

    A00XI17

    1. Remove the screw and handle.

  4. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. A00XDJM

      Remove the screw.

    2. Using a moulding remover, detach the 4 claws and clip, and then remove the cushion shield.

    3. A00XKAR

      for Driver Side:

      Detach the 5 wire harness clamps and disconnect the 2 connectors.

  5. REMOVE LUMBAR SWITCH ASSEMBLY

    A0094GK

    1. Remove the 2 screws and switch.