POWER SEAT CONTROL ECU (for Rear No. 2 Seat) REMOVAL

Note


  • If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU Click here.

  • If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU Click here.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE DECK BOARD ASSEMBLY


    1. Operate the No. 2 fold seat switch and fold down the 2 seatbacks.

    2. A009BOM

      Remove the 2 bolts.

    3. Detach the 4 clips and remove the deck board.

  2. REMOVE FOLD SEAT CONTROL ECU


    1. A0095UI

      Disconnect the 2 connectors.

    2. Remove the 2 nuts and ECU.