REAR FLOOR AIRBAG SENSOR INSTALLATION


  1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note


      • w/ Navigation System (for HDD):

        After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    3. Install the rear floor airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the rear floor airbag sensor is not loose.

    5. Connect the connector.

  2. INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER


    1. Attach the clip and claw to install the cover.

    2. Return the floor carpet to its original position.

  3. INSTALL REAR DOOR SCUFF PLATE LH


    1. Attach the 3 clips, 6 claws and 2 guides to install the rear door scuff plate.

  4. INSTALL REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)


    1. Install the quarter scuff plate with the 2 bolts.

  6. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

    Tech Tips

    Use the same procedure described for the LH side.

  7. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Tech Tips

    Use the same procedure for all rear No. 1 floor step covers.


    1. Attach the 2 claws to install the rear No. 1 floor step cover.

  8. INSTALL REAR NO. 1 SEAT ASSEMBLY


    1. for 60/40 Split Double-folding Seat Type LH Side:


      1. Install the rear No. 1 seat assembly Click here.

    2. for 60/40 Split Double-folding Seat Type RH Side:


      1. Install the rear No. 1 seat assembly Click here.

    3. for 60/40 Split Tumble Seat Type LH Side:


      1. Install the rear No. 1 seat assembly Click here.

    4. for 60/40 Split Tumble Seat Type RH Side:


      1. Install the rear No. 1 seat assembly Click here.

    5. for 60/40 Split Slide Walk-in Seat Type LH Side:


      1. Install the rear No. 1 seat assembly Click here.

    6. for 60/40 Split Slide Walk-in Seat Type RH Side:


      1. Install the rear No. 1 seat assembly Click here.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.