COMBINATION METER REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.

    2. Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the ignition switch off.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    A00O9INE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument cluster finish panel ornament.

    2. Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.

  4. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    A00O5V3

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish plate garnish.

  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    A00O3HL

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish panel.

  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A00JZZRE01
      Text in Illustration
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Detach the 4 claws.

    3. A00JYLN

      Detach the 4 claws.

    4. Detach the 2 clips and 2 guides.

    5. Disconnect the connector and remove the finish panel.

  7. REMOVE COMBINATION METER ASSEMBLY


    1. A00JVAZ

      Remove the 4 screws.

    2. Disconnect the connector and remove the combination meter.