CAN COMMUNICATION SYSTEM (for LHD with Entry and Start System) Certification ECU Communication Stop Mode

DESCRIPTION

Detection Item Symptoms Trouble Area
Certification ECU Communication Stop Mode

Either condition is met:


  • "Certification (Smart)" is not displayed on "Bus Check".

  • "Certification ECU Communication Stop Mode" in "DTC Combination Table" applies.

  • Power source or inside certification ECU

  • Certification ECU branch wire or connector

  • Certification ECU

WIRING DIAGRAM

A00O3CGE07

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tech Tips

Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note


      • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    NEXT

  2. CHECK FOR OPEN IN CAN BUS WIRE (CERTIFICATION ECU BRANCH WIRE)


    1. A00O62ME10
      Text in Illustration
      *a

      Rear view of wire harness connector

      (to Certification ECU)

      Disconnect the G38 certification ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      G38-9 (CANH) - G38-10 (CANL) Engine switch off 54 to 69 Ω

    NG

    REPAIR OR REPLACE CERTIFICATION ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)

    OK

  3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND)


    1. A00O62ME11
      Text in Illustration
      *a

      Rear view of wire harness connector

      (to Certification ECU)

      Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G38-15 (E) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      G38-1 (+B) - Body ground Always 11 to 14 V
      G38-16 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      G38-17 (CUTB) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE CERTIFICATION ECU