POWER MANAGEMENT CONTROL ECU REMOVAL

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.


    1. for 5 Door:

      Remove the door scuff plate assembly LH Click here.

    2. for 3 Door:

      Remove the door scuff plate assembly LH Click here.

  3. REMOVE COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure described for the LH side.


    1. for 5 Door:

      Remove the cowl side trim board LH Click here.

    2. for 3 Door:

      Remove the cowl side trim board LH Click here.

  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Remove the screw.

    2. Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

      A00OAYQE01
      Text in Illustration
      *A for LHD *B for RHD

  5. REMOVE INSTRUMENT SIDE PANEL RH

    A00XGN2E01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel.

    2. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

    3. Disconnect the connector and remove the instrument side panel.

  6. REMOVE INSTRUMENT PANEL ORNAMENT

    A00XGFYE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel ornament.

    2. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.

  7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A00XDSKE01
    Text in Illustration
    *1 Bolt
    *2 Screw

    1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

    2. Detach the 5 clips and claw.

    3. Disconnect each connector and remove the glove compartment door.

  8. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    1. A00O3YC

      Remove the screw.

    2. Detach the 2 claws and remove the No. 2 air duct sub-assembly.

  9. REMOVE ECU INTEGRATION BOX RH

    A00O3L2

    1. Disconnect all the connectors.

    2. Detach the clamp.

    3. Remove the 2 nuts, bolt and ECU integration box RH.

  10. REMOVE POWER MANAGEMENT CONTROL ECU

    A00O8QU

    1. Detach the 2 claws and remove the power management control ECU.