CLEARANCE WARNING ECU (for RHD) INSTALLATION


  1. INSTALL CLEARANCE WARNING ECU ASSEMBLY


    1. Install the clearance warning ECU with the bolt.

    2. Connect the connector.

  2. INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY


    1. A0095WR

      Attach the claw to install the connector as shown in the illustration.

      Note

      Be sure to connect each connector securely.

    2. A0097UT

      Attach the 2 claws to lock the connector lock as shown in the illustration.

    3. A0097WY

      Attach the claw to connect the connector as shown in the illustration.

      Note

      Be sure to connect the connector securely.

    4. Install the driver side junction block assembly with the bolt and 2 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    5. A009APZE07

      Connect the connector labeled (1).

      Note

      Be sure to connect each connector securely.

    6. Attach the 2 claws to connect the 2 connectors labeled (2) as shown in the illustration.

      Note

      Be sure to connect each connector securely.

    7. Connect the 3 connectors.

      Note

      Be sure to connect each connector securely.

  3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Install the lower No. 1 instrument panel airbag with the 4 bolts.

    2. Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector and each cable.

    2. Attach the 14 clips to install the lower instrument panel finish panel.

    3. Install the 2 bolts.

    4. Attach the 2 claws to close the cover.

  5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

    2. Install the screw.

      A00OAYQE01
      Text in Illustration
      *A for LHD *B for RHD

  6. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH


    1. Connect each connector.

    2. Attach the 4 clips to install the instrument panel finish plate garnish.

  7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    1. Connect each connector.

    2. Attach the 4 clips to install the instrument panel finish panel.

  8. INSTALL INSTRUMENT SIDE PANEL RH


    1. Attach the 5 clips, claw and 3 guides to install the instrument side panel.

  9. INSTALL COWL SIDE TRIM BOARD RH


    1. Attach the clip and claw to install the cowl side trim board.

    2. Install the clip.

  10. INSTALL DOOR SCUFF PLATE ASSEMBLY RH


    1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.