SIDE MONITOR SYSTEM (w/ Parking Assist Monitor System) HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the side monitor system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the voltage with the ignition switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  3. CHECK NAVIGATION SYSTEM


    1. Refer to the navigation system (for HDD) Click here.

    2. Refer to the navigation system (for DVD) Click here.

      Result
      Result Proceed to
      Navigation system is normal A
      Navigation system (for HDD) is abnormal B
      Navigation system (for DVD) is abnormal C

      B

      GO TO NAVIGATION SYSTEM (for HDD) Click here

      C

      GO TO NAVIGATION SYSTEM (for DVD) Click here

      A

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD with Entry and Start System) B
      CAN DTC is output (for LHD without Entry and Start System) C
      CAN DTC is output (for RHD with Entry and Start System) D
      CAN DTC is output (for RHD without Entry and Start System) E

      B

      GO TO CAN COMMUNICATION SYSTEM Click here

      C

      GO TO CAN COMMUNICATION SYSTEM Click here

      D

      GO TO CAN COMMUNICATION SYSTEM Click here

      E

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  5. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTC Click here.

    3. Check for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note

      The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

      System Proceed to
      Parking Assist Monitor System

      Click here

      Wide View Front Monitor System

      Click here

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

      B

      Go to step 8
      A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 8
      A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING


    1. Refer to Terminals of ECU Click here.


      NEXT

  8. ADJUST, REPAIR OR REPLACE


    NEXT

  9. CONFIRMATION TEST


    NEXT
    END