WIDE VIEW FRONT MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedures to troubleshoot the wide view front monitor system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the ignition switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.


      NEXT

  3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD with Entry and Start System) B
      CAN DTC is output (for LHD without Entry and Start System) C
      CAN DTC is output (for RHD with Entry and Start System) D
      CAN DTC is output (for RHD without Entry and Start System) E

      B

      Go to CAN COMMUNICATION SYSTEM Click here

      C

      Go to CAN COMMUNICATION SYSTEM Click here

      D

      Go to CAN COMMUNICATION SYSTEM Click here

      E

      Go to CAN COMMUNICATION SYSTEM Click here

      A

  4. CHECK DTC OUTPUT*


    1. Check for DTCs Click here.

    2. Clear the DTCs Click here.

    3. Check for DTCs Click here.

      Result
      Result Proceed to
      No DTC is output A
      DTC is output B

      B

      Go to DIAGNOSTIC TROUBLE CODE CHART Click here

      A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      B

      Go to step 7
      A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU Click here.


      NEXT

  7. ADJUST, REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END