NAVIGATION ANTENNA REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


    1. Remove the instrument panel safety pad Click here.

  3. REMOVE NO. 1 HEATER TO REGISTER DUCT

    A0098SE

    1. Remove the 4 screws <A> and No. 1 heater to register duct.

  4. REMOVE NO. 2 HEATER TO REGISTER DUCT

    Tech Tips

    Use the same procedure described for the No. 1 heater to register duct.

  5. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

    A0097BA

    1. Remove the screw <A>.

    2. Detach the 2 claws and remove the No. 1 side defroster nozzle duct.

  6. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

    Tech Tips

    Use the same procedure described for the No. 1 side defroster nozzle duct.

  7. REMOVE DEFROSTER NOZZLE ASSEMBLY

    A0099H9

    1. Remove the 4 screws <A> and defroster nozzle.

  8. REMOVE NAVIGATION ANTENNA ASSEMBLY


    1. A00JYJY

      Detach the 2 clamps.

    2. Remove the 2 screws and navigation antenna.