LIGHTING SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / (desired system) / Data List.

    5. According to the display on the intelligent tester, read the Data List.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG SW Ignition switch ON signal / ON or OFF

      ON: Ignition switch ON

      OFF: Ignition switch off

      		 -
      RR Door Courtesy SW*5 Rear door courtesy light switch RH / ON or OFF

      ON: Rear door RH open

      OFF: Rear door RH closed

      		 -
      RL Door Courtesy SW*5 Rear door courtesy light switch LH / ON or OFF

      ON: Rear door LH open

      OFF: Rear door LH closed

      		 -
      Back Door Courtesy SW Back door courtesy switch signal / ON or OFF

      ON: Back door open

      OFF: Back door closed

      		 -
      Glass Hatch Courtesy Switch*1 Glass hatch courtesy switch signal / ON or OFF

      ON: Glass hatch open

      OFF: Glass hatch closed

      		 -
      FR Door Courtesy Front door courtesy light switch RH signal / ON or OFF

      ON: Front door RH closed

      OFF: Front door RH open

      		 -
      FL Door Courtesy Front door courtesy light switch LH signal / ON or OFF

      ON: Front door LH closed

      OFF: Front door LH open

      		 -
      Dimmer SW Headlight dimmer switch high position signal / ON or OFF

      ON: Headlight dimmer switch in high or high flash position

      OFF: Headlight dimmer switch in low position

      		 -
      Passing Light SW Headlight dimmer switch high flash position (pass) signal / ON or OFF

      ON: Headlight dimmer switch in high flash position

      OFF: Headlight dimmer switch not in high flash position

      		 -
      Rear Fog Light SW*2 Rear fog light switch signal / ON or OFF

      ON: Rear fog light switch on

      OFF: Rear fog light switch off

      		 -
      Front Fog Light SW*3 Front fog light switch signal / ON or OFF

      ON: Front fog light switch on

      OFF: Front fog light switch off

      		 -
      Auto Light SW*4 Headlight dimmer switch AUTO position signal / ON or OFF

      ON: Headlight dimmer switch in AUTO position

      OFF: Headlight dimmer switch not in AUTO position

      		 -
      Head Light SW (Head) Headlight dimmer switch head position signal / ON or OFF

      ON: Headlight dimmer switch in head position

      OFF: Headlight dimmer switch not in head position

      		 -
      Head Light SW (Tail) Headlight dimmer switch tail position signal / ON or OFF

      ON: Headlight dimmer switch in tail or head position

      OFF: Headlight dimmer switch in neither tail nor head position

      		 -
      Illumination Rate Info*4 Illumination rate information / 0 ms. to 99.99 ms. Value output according to ambient light levels -

      • *1: w/ Glass Hatch

      • *2: w/ Rear Fog Light

      • *3: w/ Front Fog Light

      • *4: w/ Automatic Light Control System

      • *5: for 5 Door

      AFS
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      AFS OFF Switch AFS OFF switch signal / ON or OFF

      ON: AFS off

      OFF: AFS on

      		 -
      Traveling Direction Traveling direction / Not Fwd or Fwd

      Not Fwd: Shift lever in R or N

      Fwd: Shift lever in any position except R or N

      		 -
      Headlight Low Beam State Low beam headlight state / ON or OFF

      ON: Low beam headlights on

      OFF: Low beam headlights off

      		 -
      Headlight High Beam State High beam headlight state / ON or OFF

      ON: High beam headlights on

      OFF: High beam headlights off

      		 -
      DRL State*3 State of DRL / ON or OFF

      ON: DRL operating

      OFF: DRL not operating

      		 -
      Engine Engine condition / Run or Stop

      Run: Engine running

      Stop: Engine stopped

      		 -
      +B IG power supply voltage value / 0 to 19.75 V 11 to 14 V -
      Height Sens Pw Supply Val Height control sensor power supply value / 0 to 6.25 V Approx. 5 V -
      Rr Height Sens Signal Val Rear height control sensor signal value / 0 to 5 V 0.5 to 4.5 V The value changes according to the vehicle height.
      Steering Sens Signal Steering angle sensor signal value / -384 deg to 382.5 deg Approx. 0 deg (with steering wheel straight) The value changes according to the steering wheel position.
      Steering Sens Center Pos Steering angle sensor center position / -3072 deg to 3070.5 deg Condition can be displayed -
      FR Wheel Speed Front right wheel speed / 0 to 327.67 km/h Condition can be displayed -
      FL Wheel Speed Front left wheel speed / 0 to 327.67 km/h Condition can be displayed -
      Vehicle Speed Vehicle speed / 0 to 327.67 km/h Condition can be displayed -
      Rear Height Adjust Valid Flag Rear height adjustment range / VALID or INVALID Condition can be displayed -
      Init Writing Count Number of times initialization performed / 0 to 255 Condition can be displayed -
      Sensor Initialization Hist Sensor initialization history / not comp, 10%, 25%, 50%, 75%, 100% or complied Condition can be displayed -
      L Swivel Target Step Swivel motor LH target step value / 0 to 400 step

      8 to 160 step*1

      8 to 109 step*2

      		 -
      L Swivel Current Step Swivel motor LH current step value / 0 to 400 step

      8 to 160 step*1

      8 to 109 step*2

      		 -
      R Swivel Target Step Swivel motor RH target step value / 0 to 400 step

      8 to 109 step*1

      8 to 160 step*2

      		 -
      R Swivel Current Step Swivel motor RH current step value / 0 to 400 step

      8 to 109 step*1

      8 to 160 step*2

      		 -
      LR Leveling Target Step Leveling motor LH and RH target step value / 0 to 300 step 5 to 277 step -
      L Leveling Current Step Leveling motor LH current step value / 0 to 300 step 5 to 277 step -
      R Leveling Current Step Leveling motor RH current step value / 0 to 300 step 5 to 277 step -
      Number Of Trouble Codes Number of trouble codes / 0 to 255 Condition can be displayed -

      • *1: for LHD

      • *2: for RHD

      • *3: w/ Daytime Running Light System

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / (desired system) / Active Test.

    5. According to the display on the intelligent tester, perform the Active Test.

      Main Body
      Tester Display Test Part Control Range Diagnostic Note
      Hazard Hazard signal ON/OFF -
      Daytime Running Light*1 Daytime running light relay ON/OFF -
      Taillight Relay Taillight relay ON/OFF -
      Headlight Relay Low beam headlight relay ON/OFF -
      Head Light Hi Headlight dimmer relay ON/OFF -
      Front Fog Light Relay*2 Front fog light relay ON/OFF The headlight dimmer switch is in the tail position.
      Rear Fog Light Relay*3 Rear fog light relay ON/OFF The headlight dimmer switch is in the tail position.

      • *1: w/ Daytime Running Light System

      • *2: w/ Front Fog Light

      • *3: w/ Rear Fog Light

      AFS
      Tester Display Test Part Control Range Diagnostic Note
      Drive The Leveling Motor UP* Leveling motor upward operation ON/OFF

      ON: Move up

      OFF: Stop
      Drive The Leveling Motor DOWN* Leveling motor downward operation ON/OFF

      ON: Move down

      OFF: Stop
      Drive Swivel Motor LH LEFT* Swivel motor LH left direction rotation ON/OFF

      ON: Move left

      OFF: Stop
      Drive Swivel Motor LH RIGHT* Swivel motor LH right direction rotation ON/OFF

      ON: Move right

      OFF: Stop
      Drive Swivel Motor RH LEFT* Swivel motor RH left direction rotation ON/OFF

      ON: Move left

      OFF: Stop
      Drive Swivel Motor RH RIGHT* Swivel motor RH right direction rotation ON/OFF

      ON: Move right

      OFF: Stop
      AFS OFF Indicator AFS OFF indicator ON/OFF -

      • *: Perform the Active Test with the engine running and the vehicle stopped.