HEADLIGHT ASSEMBLY (for HID Headlight) DISASSEMBLY

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE NO. 1 HEADLIGHT BACK COVER


    1. A009837

      Turn the back cover in the direction indicated by the arrow and remove it.

  2. REMOVE DISCHARGE HEADLIGHT BULB


    1. A0097SV

      Turn the headlight control ECU socket in the direction indicated by the arrow and disconnect the headlight control ECU socket.

    2. A0098OJ

      Release the set spring lock as shown in the illustration and remove the bulb.

      Note

      Do not touch the glass part of the bulb.

  3. REMOVE NO. 2 HEADLIGHT BULB


    1. A0094J0

      Turn the bulb in the direction indicated by the arrow and remove it.

  4. REMOVE CLEARANCE LIGHT BULB


    1. A009C2K

      Turn the socket in the direction indicated by the arrow and remove it.

    2. Remove the bulb.

  5. REMOVE FRONT TURN SIGNAL LIGHT SOCKET


    1. A0095QN

      Turn the socket in the direction indicated by the arrow and remove it.

  6. REMOVE FRONT TURN SIGNAL LIGHT BULB


    1. Remove the bulb.

  7. REMOVE HEADLIGHT LEVELING MOTOR LH


    1. A009BN6

      Align the notches of the headlight leveling motor and housing, and pull out the headlight leveling motor slightly.

      Tech Tips

      For the headlight leveling motor RH, rotate it in the opposite direction of the arrow shown in the illustration before pulling it out.

    2. A0095CW

      Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.

  8. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH


    1. A00972X

      Remove the 4 screws.

    2. A00946Y

      Disconnect the connector and remove the headlight light control ECU sub-assembly.

  9. REMOVE HEADLIGHT GASKET


    1. Remove the gasket.

  10. REMOVE HEADLIGHT REFLECTOR LH


    1. A009BD7

      Turn the aiming screw clockwise, and move the motor so that it can be removed.

    2. A009AV6

      Disconnect the connector.

    3. Remove the 3 screws.

    4. A009AN2

      Apply tape as shown in the illustration.

    5. A0097DS

      Remove the headlight reflector LH as shown in the illustration.

      Note

      Make sure not to damage the headlight control ECU socket harness.