NOISE FILTER REMOVAL


  1. REMOVE BACK DOOR CENTER GARNISH


    1. A00JXPP

      Detach the 4 clips and remove the back door center garnish.

  2. REMOVE BACK DOOR SIDE GARNISH LH


    1. A00JW8G

      Detach the 2 clips and claw and remove the back door side garnish.

  3. REMOVE BACK DOOR SIDE GARNISH RH


    1. A00JXPA

      Detach the 2 clips and claw and remove the back door side garnish.

  4. REMOVE BACK DOOR TRIM COVER


    1. A00JZC7

      Remove the back door trim cover as shown in the illustration.

  5. REMOVE UPPER TOOL BOX PANEL SUB-ASSEMBLY


    1. A00JV27

      Remove the upper tool box panel sub-assembly as shown in the illustration.

  6. REMOVE TOOL CASE


    1. A00JTVV

      Detach the 2 claws and remove the tool case.

  7. REMOVE BACK DOOR LOCK COVER (w/o Back Door Tire Carrier)


    1. A00JXCC

      Using moulding remover B, detach the clip and 6 claws and remove the back door lock cover.

  8. REMOVE BACK DOOR INSIDE HANDLE BEZEL (for Face to Face Seat Type)


    1. A00K0S7

      Remove the screw.

    2. Detach the 5 claws and remove the back door inside handle bezel.

  9. REMOVE BACK DOOR TRIM PANEL ASSEMBLY


    1. A00JWOS

      Detach the claw and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A00JZLH

      Remove the screw.

    3. w/o Back Door Tire Carrier:


      1. A00JX6B

        Remove the bolt.

      2. Detach the 15 clips and remove the back door trim panel assembly.

    4. w/ Back Door Tire Carrier:


      1. A00JZAO

        Remove the bolt.

      2. Detach the 16 clips and remove the back door trim panel assembly.

    5. for Face to Face Seat Type:


      1. A00K0PU

        Remove the screw and bolt.

      2. Detach the 15 clips and remove the back door trim panel assembly.

  10. REMOVE RADIO SETTING CONDENSER

    Note

    If it is necessary to replace the radio setting condenser or terminal cover, both parts must be replaced as they are supplied as a set.


    1. A0098NQE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 8 claws and remove the terminal cover with wire harness from the condenser.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A00961F

      Remove the bolt.

    3. Detach the clamp from the vehicle body and remove the condenser.