MULTI-MEDIA INTERFACE ECU REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE INSTRUMENT SIDE PANEL RH

    A00O6GKE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel.

    2. Using a moulding remover, detach the 5 clips, claw, and 3 guides.

    3. Disconnect the connector and remove the instrument side panel.

  3. REMOVE INSTRUMENT PANEL ORNAMENT

    A00O57HE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel ornament.

    2. Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.

  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Remove the screw.

    2. Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.

      A00OAYQE01
      Text in Illustration
      *A for LHD *B for RHD

  5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A00O698E01
    Text in Illustration
    *1 Bolt
    *2 Screw

    1. Remove the 2 bolts <C> and 2 screws <A> or <B>.

    2. Detach the 5 clips and claw.

    3. Disconnect each connector and remove the glove compartment door.

  6. REMOVE MULTI-MEDIA INTERFACE ECU


    1. A00JW7G

      Disconnect the 3 connectors.

    2. Remove the 2 nuts and multi-media interface ECU.

  7. REMOVE NO. 1 MULTI-MEDIA INTERFACE BRACKET


    1. A00JX5Y

      Remove the bolt and No. 1 multi-media interface bracket.

  8. REMOVE NO. 2 MULTI-MEDIA INTERFACE BRACKET


    1. A00JVH7

      Remove the bolt and No. 2 multi-media interface bracket.