REAR DOOR SPEAKER REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH


    1. A00JU4V

      Using moulding remover A, detach the 3 claws and remove the rear door inside handle bezel as shown in the illustration.

  3. REMOVE ASSIST GRIP COVER LH


    1. A00JWBB

      Using moulding remover A, detach the 8 claws and remove the assist grip cover.

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A00JUUV

      Remove the 3 screws.

    2. Using a clip remover, detach the 9 clips.

    3. A00JYYA

      Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.

    4. Raise the rear door trim board sub-assembly to detach the 4 claws and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.

    5. A00JXW6

      Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly as shown in the illustration.

    6. A00JZVPE02
      Text in Illustration
      *A for 14 Speakers
      *B for 9 Speakers

      Disconnect each connector.

    7. A00JVQF

      Using a screwdriver, detach the claw and remove the clamp.

  5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH


    1. A00JU0U

      Using a screwdriver, detach the 3 claws and remove the rear door inner glass weatherstrip from the rear door trim board sub-assembly as shown in the illustration.

  6. REMOVE REAR SPEAKER SET


    1. A00JZU7

      Disconnect the connector.

    2. Remove the 3 screws.

    3. Detach the 2 claws and remove the rear speaker set.

      Note

      Do not touch the cone of the speaker.

  7. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 14 Speakers)


    1. A00JUFU

      Remove the 2 screws and No. 2 speaker.

      Note

      Do not touch the cone of the speaker.