RADIO RECEIVER INSTALLATION


  1. INSTALL NO. 2 RADIO BRACKET (for Upper Side)


    1. Install the bracket with the 4 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  2. INSTALL NO. 2 RADIO BRACKET (for Lower Side)


    1. Install the bracket with the 3 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  3. INSTALL NO. 1 RADIO BRACKET (for Upper Side)


    1. Install the bracket with the 3 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  4. INSTALL NO. 1 RADIO BRACKET (for Lower Side)


    1. Install the bracket with the 3 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  5. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Upper Side)


    1. Connect the connectors.

    2. Install the radio receiver with the 4 bolts.

      Torque:
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

  6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Upper Side)


    1. Attach the 10 clips to install the center instrument cluster finish panel.

  7. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Lower Side)


    1. Connect the connectors.

    2. A009A3I

      Insert the radio receiver to attach the 3 clamps on its backside.

      Note

      When inserting the radio receiver, do not press the knobs on it.

    3. Install the radio receiver with the 4 bolts.

      Torque:
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

  8. INSTALL FRONT UPPER CONSOLE PANEL GARNISH (for Lower Side)


    1. Attach the 5 clips to install the front console upper panel garnish.

  9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for Lower Side)


    1. Attach the 4 clips to install the instrument panel finish panel end.

  10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH (for Lower Side)


    1. Connect the connector.

    2. Attach the 4 clips to install the instrument panel finish panel end.

  11. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

    A0095V3

    1. Connect the connector.

    2. Attach the 4 clips to install the integration control and panel assembly.

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.