AUDIO AND VISUAL SYSTEM (w/o Navigation System), Diagnostic DTC:01-DC

DTC Code DTC Name
01-DC Transmission Error

DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
01-DC Transmission to the component shown by the sub-code failed (Detecting this DTC does not always mean actual failure). If the same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code

Tech Tips

This code may be stored if the engine is started and idled for 60 seconds and then the ignition switch is turned to the start position again.

Note


  • Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in Hint above. Then, check for DTCs and troubleshoot according to the output DTCs.

  • The radio receiver assembly is the master unit.

  • Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.

INSPECTION PROCEDURE

Note

Be sure to read Description before performing the following procedures.

PROCEDURE


  1. CHECK FOR DTC OF OTHER COMPONENTS


    1. Check if the component shown by the sub-code is displayed in the check result of the other components.


      1. Check if "01-DC" is output for the other components.

      2. If "01-DC" is output for any other components, check if the same physical address is displayed.

        Tech Tips

        For the list of the components shown by sub-codes, refer to the table in the next step.

        Result
        Result Proceed to
        "01-DC" is not output or the same physical address is not displayed A
        "01-DC" is output and the same physical address is displayed B

    B

    IDENTIFY COMPONENT WHICH HAS STORED THIS CODE Click here

    A

  2. CHECK FOR DTC


    1. Clear the DTCs Click here.

      Tech Tips

      If "01-DC" is output for only one component, this may not indicate a malfunction.

    2. Check for DTCs and check if the same trouble occurs again.

      OK
      The malfunction disappears.

    NG

    CHECK COMPONENT WHICH HAS STORED THIS CODE Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  3. IDENTIFY COMPONENT WHICH HAS STORED THIS CODE


    1. Enter the diagnostic mode.

      A009BNWE10

    2. Press the preset switch "channel 3" to change to "Detailed Information Mode".

    3. Identify the component which has stored this code.

      Component Table
      Component Physical Address
      Radio receiver assembly 190
      "Bluetooth" handsfree module 19D
      Stereo component amplifier assembly* 440
      Multi-media interface ECU 388

      • *: for 9 Speakers

      Tech Tips


      • "440 (stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.

      • For details of the DTC display, refer to DTC Check/Clear Click here.


    NEXT

  4. CHECK COMPONENT WHICH HAS STORED THIS CODE


    1. Select the component which has stored this code.

      Component Table
      Component Proceed to
      Radio receiver assembly

      Radio receiver communication error Click here

      "Bluetooth" handsfree module

      "Bluetooth" handsfree module communication error Click here

      Stereo component amplifier assembly*

      Stereo component amplifier communication error Click here

      Multi-media interface ECU

      Multi-media interface ECU communication error Click here


      • *: for 9 Speakers


    NEXT

    END