AUDIO AND VISUAL SYSTEM (w/ Navigation System), Diagnostic DTC:B15BB

DTC Code DTC Name
B15BB Multi-media Interface ECU Malfunction

DESCRIPTION

This DTC is stored when a malfunction occurs in the multi-media interface ECU.

DTC Code DTC Detection Condition Trouble Area
B15BB

Either condition is met:


  • System microprocessor malfunction.

  • Media interface microprocessor malfunction.

  • CD-LSI (Large Scale Integration) malfunction.

  • Internal power supply malfunction.

  • USB device or "iPod"

  • Harness or connector

  • No. 1 stereo jack adapter assembly

  • Multi-media interface ECU

WIRING DIAGRAM

A0098CUE69

INSPECTION PROCEDURE

Tech Tips

After the inspection is completed, clear the DTC.

PROCEDURE


  1. REPLACE "iPod" OR USB DEVICE


    1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

    2. Turn the ignition switch off.

      Tech Tips

      When this DTC has been stored, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.

    3. Turn the ignition switch to ACC.

    4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

      Tech Tips


      • If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


    NEXT

  2. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs and check if the same trouble occurs again.

      OK
      No DTC is output.

    NG

    CHECK MULTI-MEDIA INTERFACE ECU Click here

    OK

    USB DEVICE OR "iPod" WAS DEFECTIVE

  3. CHECK MULTI-MEDIA INTERFACE ECU


    1. A0099R4E04
      Text in Illustration
      *a

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Disconnect the H39 No. 1 stereo jack adapter assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H39-1 (UJSG) - H39-4 (UPI) Always 5 V

    NG

    CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER) Click here

    OK

    REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY Click here

  4. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)


    1. Disconnect the H40 multi-media interface ECU connector.

    2. Disconnect the H39 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H39-1 (UJSG) - H40-1 (UESG) Always Below 1 Ω
      H39-4 (UPI) - H40-4 (UPO) Always Below 1 Ω
      H39-1 (UJSG) - Body ground Always 10 kΩ or higher
      H39-4 (UPI) - Body ground Always 10 kΩ or higher

    NG

    REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE MULTI-MEDIA INTERFACE ECU Click here