DRIVING SUPPORT SWITCH CONTROL ECU INSTALLATION


  1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU


    1. Install the driving support switch control ECU with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

    2. Connect the connector.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    A00O698E01
    Text in Illustration
    *1 Bolt
    *2 Screw

    1. Connect each connector.

    2. Attach the 5 clips and claw to install the glove compartment door.

    3. Install the 2 bolts <C> and 2 screws <A> or <B>.

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

    2. Install the screw.

      A00OAYQE01
      Text in Illustration
      *A for LHD *B for RHD

  4. INSTALL INSTRUMENT PANEL ORNAMENT


    1. Attach the 5 clips to install the instrument panel ornament.

  5. INSTALL INSTRUMENT SIDE PANEL RH


    1. Connect the connector.

    2. Attach the 5 clips, claw and 3 guides to install the instrument side panel.

  6. INSTALL COWL SIDE TRIM BOARD RH


    1. Attach the clip and claw to install the cowl side trim board.

    2. Install the clip.

  7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH


    1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. CHECK SRS WARNING LIGHT

    Click here