STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) REASSEMBLY


  1. INSTALL KEY INTERLOCK SOLENOID WIRE (w/o Entry and Start System)


    1. Install the key interlock solenoid wire on to the install the ignition switch.

  2. INSTALL IGNITION SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A00JX5S

      Install the ignition switch onto the steering column upper bracket with the 2 screws.

  3. INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System for Automatic trans mission)


    1. A00K0JX

      Install the key interlock solenoid onto the steering column upper bracket with the 2 screws.

    2. Connect the connector.

  4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A00JX5T

      Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.

      Tech Tips

      Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.

  5. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)


    1. Turn the ignition switch to ON (ACC).

    2. A00K07R

      Install the ignition switch lock cylinder into the steering column upper bracket.

    3. Make sure that the ignition switch lock cylinder is securely fixed onto the ignition switch lock cylinder.

  6. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)


    1. A00JZLK

      Remove the key and check that the steering lock function is activated.

    2. A00JU10

      Insert the key, turn the ignition switch ON (ACC) and check that the steering lock function is deactivated.

  7. INSTALL STEERING LOCK ACTUATOR ASSEMBLY


    1. Temporarily install the steering lock actuator assembly with a new tapered-head bolt.

    2. A00K1W1E01
      Text in Illustration
      *A w/o Entry and Start System
      *B w/ Entry and Start System

      Tighten the tapered-head bolt until the bolt head breaks off.