VANE PUMP (for 1GR-FE) REMOVAL

Note


  • When using a vise, do not overtighten it.

  • When installing the parts indicated by arrows, coat them with power steering fluid Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT WHEEL RH

  3. REMOVE FRONT FENDER APRON SEAL RH


    1. A00L0IO

      Remove the 4 clips and fender apron seal.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A00OAQRE01
      Text in Illustration
      *1 Pin
      *2 Hook

      Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  5. REMOVE AIR CLEANER CAP AND HOSE


    1. A0097JZ

      Remove the air cleaner cap and hose.


      1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

      2. Loosen the clamp.

      3. Unfasten the 4 hook clamps, and then remove the bolt and air cleaner cap and hose.

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE

  8. REMOVE FAN AND GENERATOR V BELT


    1. A0097XF

      While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

      Tech Tips

      The pulley bolt for the belt tensioner has a left-hand thread.

    2. Remove the V belt.

  9. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


    1. A00JU6H

      Disconnect the 2 connectors.

  10. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    1. A00K23Z

      Slide the clip and disconnect the oil reservoir to pump hose from the vane pump.

  11. DISCONNECT PRESSURE FEED TUBE


    1. A00JY8F

      Remove the union bolt and disconnect the pressure feed tube.

    2. Remove the gasket.

  12. REMOVE VANE PUMP ASSEMBLY


    1. A00JVEU

      Remove the bolt and harness bracket.

    2. A00JTPV

      Remove the 2 bolts and vane pump.