PARKING BRAKE ASSEMBLY DISASSEMBLY

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR WHEEL LH

  2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A009ASS

      Remove the 2 bolts and disconnect the rear disc brake cylinder.

      Note


      • Do not disconnect the flexible hose from the disc brake cylinder.

      • Do not twist or bend the flexible hose.

    2. Hang the disc brake cylinder with a piece of wire.

  3. REMOVE REAR DISC


    1. A00JWV0E01
      Text in Illustration
      *1 Matchmark

      Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

    2. A00JUACE08

      Turn the shoe adjuster until the disc turns freely, and then remove the disc.

      Text in Illustration
      A00JWY4 Shoe Adjuster Contracts
      A00JYOS Shoe Adjuster Expands

  4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING


    1. A0095P8

      Remove the 2 parking brake shoe return tension springs.

  5. DISCONNECT NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. A0097WD

      Remove the parking brake shoe hold down spring cups and parking brake shoe hold down spring to disconnect the No. 1 parking brake shoe assembly from the backing plate.

  6. REMOVE PARKING BRAKE SHOE STRUT LH


    1. A0098MB

      Remove the parking brake shoe strut and parking brake shoe strut compression spring.

  7. DISCONNECT NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. A009ATP

      Remove the parking brake shoe hold down spring cup and parking brake shoe hold down spring to disconnect the No. 2 parking brake shoe assembly from the backing plate.

  8. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET


    1. A0095FZ

      Remove the parking brake shoe adjusting screw set.

  9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. A0099YA

      Disconnect the parking brake shoe return tension spring to remove the No. 1 parking brake shoe assembly.

  10. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING


    1. A00987N

      Remove the parking brake shoe return tension spring from the No. 2 parking brake shoe assembly.

  11. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER


    1. A0093WH

      Using needle-nose pliers, disconnect the No. 3 parking brake cable assembly from the parking brake shoe lever as shown in the illustration.

      Note

      Be careful not to damage the No. 3 parking brake cable assembly.

  12. REMOVE PARKING BRAKE SHOE LEVER LH


    1. A009B2C

      Remove the C-washer, shim and parking brake shoe lever from the No. 2 parking brake shoe assembly as shown in the illustration.

  13. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN


    1. Remove the parking brake shoe hold down spring pin (for front side).

    2. Remove the parking brake shoe hold down spring pin (for rear side).