STEERING ANGLE SENSOR INSTALLATION


  1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

    Click here

    Note


    • Do not replace the spiral cable with the battery connected and the ignition switch ON.

    • Do not rotate the spiral cable with the battery connected and the ignition switch ON.

    • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

    • Do not remove the steering angle sensor from the spiral cable.

  2. INSTALL STEERING COLUMN COVER


    1. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

    2. for Power Tilt and Power Telescopic Steering Column:

      Click here

  3. ADJUST SPIRAL CABLE


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A0094CF

      Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable with steering sensor by the airbag wire harness.

    4. A0095W3E02
      Text in Illustration
      *a Mark

      Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable with steering sensor by the airbag wire harness.

      Tech Tips

      The spiral cable with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.

  4. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SRS WARNING LIGHT

    Click here