VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster), Diagnostic DTC:C1442, C1443

DTC Code DTC Name
C1442 Invalid Data Received from Acceleration Sensor
C1443 Invalid Data Received from Yaw Rate Sensor

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

The yaw rate and acceleration sensor has a built-in acceleration sensor and detects the vehicle condition.

DTC Code DTC Detection Condition Trouble Area
C1442 An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. Yaw rate and acceleration sensor
C1443 An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more. Yaw rate and acceleration sensor

INSPECTION PROCEDURE

Note

When replacing the yaw rate and acceleration sensor, perform calibration Click here.

PROCEDURE


  1. CHECK DTC


    1. Turn the ignition switch off.

    2. Clear the DTCs Click here.

    3. Start the engine and idle it for 60 seconds, and then stop the engine.

    4. Check if the same DTC is output Click here.

      Result
      Result Proceed to
      DTC is output A
      DTC is not output B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

    REPLACE YAW RATE AND ACCELERATION SENSOR Click here