REAR SPEED SENSOR INSTALLATION

INSTALL SKID CONTROL SENSOR WIRE

1. Install the 2 sensor clamps with the 2 bolts.

   Torque:

   13 N*m  { 127 kgf*cm, 9 ft.*lbf }

   Note

   Make sure the clamp rotation stopper touches the installation position.

2. Connect the connector.

   Note

   Securely connect the connector.

3. Attach the connector.

4. Attach the 8 clamps.

   Note

   When attaching the clamps, do not twist the wire harness.

INSTALL REAR SPEED SENSOR LH

1. Install the speed sensor with the nut.

   Torque:

   7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

   Note

   
   

   • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

   • While inserting the speed sensor into the axle hole, do not strike or damage the sensor tip.

   • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle.

   • Make sure there is no foreign matter attached to the speed sensor rotor.

2. Connect the speed sensor connector.

   Note

   Securely connect the connector.

INSTALL REAR SPEED SENSOR RH

INSTALL REAR WHEEL

Torque:

112 N*m  { 1137 kgf*cm, 82 ft.*lbf }

CHECK SPEED SENSOR SIGNAL

1. w/o VSC:

   Check the speed sensor signal Click here.

2. w/ VSC (for hydraulic brake booster):

   Check the speed sensor signal Click here.

3. w/ VSC (for vacuum brake booster):

   Check the speed sensor signal Click here.