ANTI-LOCK BRAKE SYSTEM ABS Warning Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON Click here.

INSPECTION PROCEDURE

Note


  • When replacing the brake actuator assembly, perform calibration Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here.

      Result
      Result Proceed to
      DTC not output A
      DTC output for LHD without Entry and Start System B
      DTC output for RHD without Entry and Start System C

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

  2. CHECK ABS WARNING LIGHT


    1. Disconnect the skid control ECU connector.

    2. Turn the ignition switch to ON.

    3. Check that the ABS warning light comes on.

      OK
      The ABS warning light comes on.

    NG

    Click here

    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

  3. READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT)


    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ABS Warning Light ABS warning light / ON or OFF OFF -

    6. When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List Click here.

      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      ABS Warning Light ABS warning light Warning light ON/OFF Observe the combination meter.
      Result
      Result Proceed to
      Data List Display Data List Display when Performing Active Test ON/OFF Operation
      ON Does not change between ON and OFF A
      Changes between ON and OFF B
      OFF Does not change between ON and OFF A
      Changes between ON and OFF B

    B

    GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here