FRONT UPPER SUSPENSION ARM REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT WHEEL

  2. REMOVE SKID CONTROL SENSOR WIRE


    1. A00JXF6

      Disconnect the connector from the front speed sensor.

    2. Remove the 2 bolts and 2 harness clamps.

    3. Detach the clip.

    4. A00JZ26

      Remove the 2 bolts and 2 harness clamps.

    5. Disconnect the connector as follows.

      A00K1FHE01
      Text in Illustration
      *A for LH *B for RH

      1. for LH:


        1. Disconnect the connector.

        2. Detach the connector.

      2. for RH:


        1. Disconnect the connector.

        2. Detach the connector from the skid control sensor clamp.

        3. Detach the clip.

        4. Remove the bolt and skid control sensor clamp.

  3. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY LH


    1. A00AMMGE03

      Support the front suspension lower arm LH with a jack.

    2. Remove the clip and nut.

    3. Using SST, disconnect the upper ball joint from the steering knuckle.

      SST
      09628-62011
    4. A00AOVC

      Remove the bolt and disconnect the bracket.

    5. A00ALX7

      Remove the bolt, 2 washers and nut.

    6. Remove the front suspension upper arm assembly.