ABSORBER CONTROL SWITCH REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    A00XK5H

    1. Detach the 4 clips.

    2. Disconnect each connector and remove the instrument panel finish panel.

  3. REMOVE ABSORBER CONTROL SWITCH


    1. A00XID5E01
      Text in Illustration
      *A for LHD
      *B for RHD

      Detach the 2 claws and remove the absorber control switch from the lower instrument panel finish panel.

      Tech Tips

      Tape the screwdriver tip before use.