CONTROL VALVE ASSEMBLY REMOVAL

Note


  • Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.

  • Check the safety of your surroundings and use caution when disconnecting each height control valve air tube as the air in each pneumatic cylinder will be discharged and the vehicle body will lower.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. DISCONNECT HEIGHT CONTROL TUBE


    1. A00JYHH

      Disconnect the connector.

    2. Disconnect the 3 height control tubes Click here.

      Tech Tips

      For the disconnection procedure of the tubes (type 1 and type 2), refer to Precaution of the Suspension Control System section.

  3. REMOVE NO. 2 HEIGHT CONTROL VALVE SUB-ASSEMBLY


    1. A00K1MU

      Remove the 2 bolts and No. 2 height control valve.