KINETIC DYNAMIC SUSPENSION SYSTEM ON-VEHICLE INSPECTION


  1. INSPECT INDICATOR LIGHT


    1. Check that the KDSS indicator light comes on for 2 seconds.

      If the indicator check result is not normal, proceed to troubleshooting for the Problem Symptoms Table Click here.

  2. INSPECT FLUID PRESSURE

    Note


    • Perform the inspection on a level surface.

    • Make sure that the wheels are on the ground and facing straight ahead.

    • Perform the inspection with the vehicle load completely on the suspension.

    Tech Tips


    • Perform this step with the fuel tank full.

    • If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.


    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Enter the following menus: Chassis / KDSS / Data List.

    6. Select the item below in the Data List, and read its value displayed on the intelligent tester.

      KDSS
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Oil Pressure Sensor

      Oil pressure sensor/

      Min.: -784.79 MPa (-8002.66 kgf/cm2, -113794.55 psi)

      Max.: 784.76 MPa (8002.35 kgf/cm2, 113790.20 psi)

      2.6 MPa (26.5 kgf/cm2, 377 psi) to 3.0 MPa (30.6 kgf/cm2, 435 psi): When vehicle stopped and fluid temperature 20°C (68°F)

      		 -

      Tech Tips

      If the value is outside the specified range, there may be fluid leaks, clogs in the hydraulic circuit, or a lack or excess of fluid.