MANUAL TRANSMISSION SYSTEM ON-VEHICLE INSPECTION


  1. CHECK TRANSMISSION OIL

    A009913E07

    1. Stop the vehicle on a level surface.

    2. Remove the filler plug and gasket.

    3. Check that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the filler plug opening.

      If the result is not as specified, add transmission oil.

      Oil grade
      API GL-4 or GL-5
      Viscosity
      SAE 75W-90
      Standard capacity
      2.2 liters (2.3 US qts, 1.9 Imp. qts)

      Note


      • Too much or too little oil will lead to transmission problems.

      • After adjusting the oil level, drive the vehicle and check the oil level again.

    4. Check for oil leakage when the oil level is low. If leakage is found, repair the area necessary to stop the leak. Replace damaged parts as necessary.

    5. Install a new gasket and the filler plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }