SHIFT LEVER INSTALLATION


  1. INSTALL SHIFT LEVER ASSEMBLY


    1. A0096YSE04

      Install the transmission floor shift with the 4 bolts tighten the bolt in the order shown in the illustration.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

    2. Connect the 2 connectors.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Turn the socket of the transmission control cable 180° counterclockwise. While holding the socket in place, push in the lock piece until the lock piece clicks twice.

      Note

      Do not over-rotate the socket as it will come off the internal spring and the transmission control cable will not be reusable.

      A0098B0E02
      Text in Illustration
      *1 Socket *2 Lock Piece
      *a Push in - -

      Tech Tips

      If the lock piece cannot be pushed in, slightly turn the socket clockwise and then push in the lock piece again.

    2. Install the outer part of the transmission control cable to the shift lever retainer. Check that the socket and lock piece are positioned at original position.

      A009BR8E01
      Text in Illustration
      *1 Shift Lever Retainer - -
    3. A009AI5E01
      Text in Illustration
      *1 Slider
      *2 Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    4. A0095DW

      Connect the end of the cable to the shift lever.

      Note


      • Make sure that the lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the pin.

    5. A009697E04

      Push the lock piece into the adjuster case and lock it.

      Note

      Make sure that the lock piece is completely locked by the slider.

  3. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

    2. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.

    3. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.

      If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the transmission floor shift assembly installation condition.

  4. INSTALL REAR CONSOLE BOX ASSEMBLY


    1. Install the rear console box Click here.

  5. INSTALL CONSOLE BOX ASSEMBLY (w/ Refrigerated Cool Box)


    1. Install the console box Click here.