TRANSMISSION WIRE REMOVAL


  1. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  2. REMOVE FRONT SUSPENSION MEMBER BRACKET LH AND RH


    1. A00O7CM

      Remove the 8 bolts, front bracket suspension member LH and front bracket suspension member RH.

  3. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV)


    1. A0099NY

      Support the transmission with a transmission jack.

    2. A009629E03

      Remove the 4 set bolts of the rear engine mounting insulator.

    3. Remove the 4 nuts, 4 bolts and frame crossmember.

  4. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR (for 1KD-FTV)

    A00OB0K

    1. Remove the 4 bolts and rear engine mounting insulator from the transmission.

  5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A0096Z5E01

      Remove the 20 bolts, oil pan and gasket from the transmission.

      Note

      Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.

    2. Examine the particles in the pan.


      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A0095UCE01

      Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the O-ring from the oil strainer.

  7. DISCONNECT TRANSMISSION WIRE

    A009821

    1. Remove the 2 bolts and 2 temperature sensor clamps.

    2. Disconnect the 2 ATF temperature sensors.

    3. Disconnect the 7 connectors from the solenoid valves.

  8. REMOVE TRANSMISSION WIRE

    A0099E6E01

    1. Disconnect the wire connector.


      1. Detach the claw, press down the lever, and then disconnect the transmission wire connector.

    2. A009C4F

      Remove the bolt and pull out the transmission wire.