SLIDING ROOF HOUSING DISASSEMBLY


  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A0095R0

      Detach the bracket claw and remove the bracket.

    2. Remove the 2 bolts and drive gear.

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

    A0095JJE01
    Text in Illustration
    *a Rearward - -

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the sliding roof piece LH and RH.

    3. Slide and remove the trim.

  3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH


    1. A009BV2

      Remove the stopper.

  4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. Remove the 2 screws and 2 stoppers.

      A009AQW
    2. A0098J2E01
      Text in Illustration
      *1 Protective Tape
      *a Rearward

      Using a screwdriver, detach the 2 claws and slide the rear roof drip channel rearward to remove it.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A00977W

      Hold down the window deflector.

    4. A0097VME01
      Text in Illustration
      *1 Matchmark A
      *2 Matchmark B

      Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.

    5. A00966ME01
      Text in Illustration
      *1 Protective Tape
      A009BSG Slide

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      Tech Tips

      Tape the screwdriver tip before use.