WIPER SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE LOWER STEERING COLUMN COVER


    1. A00JWS7

      Turn the steering wheel to the left as necessary to remove the screw.

    2. A00JZH5

      Turn the steering wheel to the right as necessary to remove the screw.

    3. A00K020

      for Power Tilt and Power Telescopic:


      1. Remove the screw.

    4. A00JWN8

      Detach the 2 claws and remove the lower steering column cover.

  3. REMOVE UPPER STEERING COLUMN COVER


    1. A00JVD1

      Detach the 4 clips and claw to remove the upper steering column cover.

  4. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A00JZOW

      w/ Rain Sensor:

      Disconnect the connector.

    2. A00K1W6

      w/o Rain Sensor:

      Disconnect the 2 connectors.

    3. Detach the claw and remove the windshield wiper switch assembly.