INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
Apply a light coat of gasoline or grease to a new gasket and install the gasket to the fuel tank.
Align the protrusion of the fuel suction with pump and gauge tube with the groove of the fuel tank.
Be careful not to bend the arm of the fuel sender gauge.
Install the fuel suction with pump and gauge tube to the fuel tank.
Put a new retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.
Make sure the start marks on the retainer and fuel tank are aligned and then tighten the retainer.
|*1||Start Mark (Fuel Tank Side)|
|*2||Start Mark (Retainer Side)|
Set SST on the retainer.
Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket in not moved out of position.
Engage the claws of SST securely with the fuel pump gauge retainer holes to secure SST.
Install SST while pressing the claws of SST against the fuel pump gauge retainer (toward the center of SST).
|*1||Fuel Tank Side Mark|
|*2||Retainer Side Mark|
Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.
Fit the tips of SST onto the ribs of the retainer.
INSTALL FUEL TANK SUB-ASSEMBLY
Install the fuel tank sub-assembly Click here.