FUEL PRESSURE PULSATION DAMPER INSTALLATION


  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. A00989SE01
      Text in Illustration
      *1 O-Ring

      Apply a light coat of gasoline or spindle oil to the O-ring.

    2. Install the fuel pressure pulsation damper with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  2. CONNECT FUEL HOSE


    1. Connect the fuel hose Click here.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSPECT FOR FUEL LEAK


    1. Make sure that there are no fuel leaks after performing maintenance on the fuel system.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON and turn the intelligent tester on.

        Note

        Do not start the engine.

      3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

      4. Check that there are no leaks from the fuel system.

        If there are fuel leaks, repair or replace parts as necessary.

      5. Turn the ignition switch off.

      6. Disconnect the intelligent tester from the DLC3.