FUEL INJECTOR INSTALLATION


  1. INSTALL FUEL INJECTOR ASSEMBLY


    1. A00O481E01
      Text in Illustration
      *1 New Insulator
      *2 New O-Ring

      Install a new insulator to each fuel injector.

    2. Apply a light coat of spindle oil or gasoline to new O-rings and install one to each fuel injector.

    3. Install the 6 injectors.


      1. A00OALZE01
        Text in Illustration
        *1 Connector
        A00O9VA Outward
        A00O5SP Turn
        A00O9ZK Push

        While turning each fuel injector left and right, install it to the fuel delivery pipe.

      2. Position the fuel injectors with the connectors facing outward.

  2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY


    1. Place the fuel delivery pipe together with the 6 fuel injectors on the intake manifold.

    2. Temporarily install the 6 bolts, which are used to hold the fuel delivery pipe in place, to the intake manifold.

    3. A00O5G3E01
      Text in Illustration
      *1 Turn

      Check that the fuel injectors rotate smoothly.

      If the fuel injectors do not rotate smoothly, replace the O-ring of any injector that does not rotate smoothly.

    4. Position the fuel injectors with the connectors facing outward.

    5. Tighten the 6 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    6. Connect the 6 fuel injector connectors.

  3. CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY


    1. Connect the No. 2 fuel pipe sub-assembly Click here.

  4. CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY


    1. Connect the No. 1 fuel pipe sub-assembly Click here.

  5. INSTALL REAR CYLINDER HEAD COVER


    1. Temporarily install the cover with the 3 bolts.

    2. A00O6K9E01

      Tighten the 3 bolts in the sequence shown in the illustration.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

  6. INSTALL INTAKE AIR SURGE TANK


    1. Install the intake air surge tank Click here.

  7. INSPECT FOR FUEL LEAK


    1. Make sure that there are no fuel leaks after performing maintenance on the fuel system.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON and turn the intelligent tester on.

        Note

        Do not start the engine.

      3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

      4. Check that there are no leaks from the fuel system.

        If there are fuel leaks, repair or replace parts as necessary.

      5. Turn the ignition switch off.

      6. Disconnect the intelligent tester from the DLC3.