ECM INSTALLATION


  1. INSTALL NO. 2 ECM BRACKET


    1. Install the No. 2 ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }
  2. INSTALL ECM BRACKET


    1. Install the ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }
  3. INSTALL ECM


    1. Install the ECM with the bolt and nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    2. Connect the 6 connectors.

  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. Install the glove compartment door Click here.

  5. PERFORM INITIALIZATION

    Note


    • Be sure to perform this procedure after reassembling the throttle body assembly or removing and reinstalling any throttle body component.

    • Perform the following procedure after replacing the ECM, throttle body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.

    • Be sure to perform this procedure after reconnecting the battery cable and after replacing the ECM.


    1. Disconnect the cable from the negative (-) battery terminal. Wait at least 60 seconds and reconnect the cable.

    2. Turn the ignition switch to ON without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

    3. Connect the tester to the DLC3 and clear the DTCs Click here.

    4. Start the engine, and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

      Engine Idle Speed
      Condition Specified Condition
      A/C switched off 600 to 700 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in N or P.

    5. Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Pos. Sensor Output. Fully depress the accelerator pedal and check that the value is 60% or more.

    6. Perform a road test and confirm that there are no abnormalities.