CRANKSHAFT POSITION SENSOR (w/o DPF) INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. Install the crankshaft position sensor with the bolt and attach the 3 clamps.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Attach the connector to the vacuum transmitting pipe and connect the crankshaft position sensor connector.

  2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. Install the No. 1 engine under cover with the 4 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  3. INSTALL FRONT BUMPER LOWER COVER


    1. Install the lower front bumper cover with the clip and 5 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }