ACCELERATOR PEDAL ON-VEHICLE INSPECTION


  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY


    1. Inspect the voltage.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the intelligent tester main switch on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accelerator Pos No. 1, Accelerator Pos No. 2.

      5. When depressing and releasing the accelerator pedal, check that the values of the accelerator pos No. 1 and accelerator pos No. 2 are within the specified range.

        Accelerator Pos No. 1 Standard Voltage
        Condition Specified Condition
        Accelerator pedal is released 0.4 to 1.4 V
        Accelerator pedal is depressed 3.0 to 4.6 V
        Accelerator Pos No. 2 Standard Voltage
        Condition Specified Condition
        Accelerator pedal is released 0.9 to 2.3 V
        Accelerator pedal is depressed 3.4 to 5.5 V

        If the result is not as specified, check the accelerator pedal, wire harness and ECM.