IGNITION COIL AND SPARK PLUG REMOVAL


  1. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. Remove the 13 clips and upper radiator support seal.

  2. REMOVE V-BANK COVER


    1. A00OAQRE01
      Text in Illustration
      *1 Pin
      *2 Hook

      Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  3. REMOVE AIR CLEANER CAP AND HOSE


    1. A0097JZ

      Remove the air cleaner cap and hose.


      1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

      2. Loosen the clamp.

      3. Unfasten the 4 hook clamps, and then remove the bolt and air cleaner cap and hose.

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. Remove the air cleaner filter element.

    2. A009AWN

      Detach the wire harness clamp.

    3. Remove the 3 bolts and air cleaner case.

  5. REMOVE AIR TUBE (w/ Secondary Air Injection System)


    1. A009AP7

      Remove the 2 bolts, 2 nuts and air tube.

    2. Remove the 2 gaskets from the air tube.

      Note

      Be careful not to damage the installation surface of the gaskets.

  6. REMOVE EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)


    1. A0098U3

      Disconnect the emission control valve set connector.

    2. Disconnect the No. 1 air hose from the emission control valve set.

    3. A009B7Y

      Remove the 3 nuts and emission control valve set.

  7. REMOVE NO. 2 AIR TUBE (w/ Secondary Air Injection System)


    1. A0096DQ

      Remove the 2 bolts, 2 nuts and No. 2 air tube.

    2. Remove the 2 gaskets from the No. 2 air tube.

      Note

      Be careful not to damage the installation surface of the gaskets.

  8. REMOVE NO. 2 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)


    1. A009AOT

      Disconnect the No. 2 emission control valve set connector.

    2. Disconnect the No. 3 air hose.

    3. A0097MM

      Remove the 3 nuts and No. 2 emission control valve set.

  9. REMOVE IGNITION COIL ASSEMBLY


    1. A0095XA

      Disconnect the 6 ignition coil connectors.

    2. Remove the 6 bolts and 6 ignition coils.

  10. REMOVE SPARK PLUG


    1. Remove the 6 spark plugs.