CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)


    1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note


      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

    2. Install the VVT sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the sensor connector.

  2. INSTALL VVT SENSOR (for Intake Side of Bank 2)


    1. Apply a light coat of engine oil to the O-ring of the sensor.

      Note


      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

    2. Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the sensor connector.

  3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)


    1. Apply a light coat of engine oil to the O-ring of the sensor.

      Note


      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

    2. Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the sensor connector.

  4. INSTALL VVT SENSOR (for Intake Side of Bank 1)


    1. Apply a light coat of engine oil to the O-ring of the sensor.

      Note


      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

    2. Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the sensor connector.

  5. INSTALL NO. 1 AIR CLEANER HOSE


    1. A00JXFZE01
      Text in Illustration
      *1 Paint mark
      *a Protrusion
      *b Groove
      *c Top
      *d RH
      *e Front

      Install the air cleaner hose with the 2 clamps.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Install the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    3. Connect the vacuum hose and ventilation hose.

      Tech Tips

      The direction of the hose clamp is indicated in the illustration.

    4. Attach the wire harness clamp.

  6. INSTALL V-BANK COVER


    1. A00K1TNE01
      Text in Illustration
      *1 Pin
      *2 Hook

      Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins and press down on the V-bank cover to attach the pins.