SHIFT LEVER INSPECTION


  1. INSPECT TRANSMISSION FLOOR SHIFT ASSEMBLY (SHIFT LOCK CONTROL ECU)

    A00980QE01
    Text in Illustration
    *a

    Component with harness connected

    (Shift Lock Control ECU)

    1. Measure the voltage and resistance according to the value(s) in the table below.

      Tech Tips

      Do not disconnect the shift lock control ECU connector.

      Standard Voltage and Resistance
      Tester Connection Condition Specified Condition
      G34-6 (ACC) - G34-8 (E) Ignition switch ON 11 to 14 V
      G34-6 (ACC) - G34-8 (E) Ignition switch ACC 11 to 14 V
      G34-6 (ACC) - G34-8 (E) Ignition switch off Below 1 V
      G34-7 (STP) - G34-8 (E) Brake pedal depressed 11 to 14 V
      G34-7 (STP) - G34-8 (E) Brake pedal released Below 1 V
      G34-12 (KLS+) - G34-8 (E) 1. Ignition switch ACC and shift lever in P Below 1 V
      2. Ignition switch ACC and shift lever not in P (Within approx. 1 second) 7.5 to 11 V
      3. Ignition switch ACC and shift lever not in P (After approx. 2 seconds) 6 to 9.5 V
      G34-1 (IG) - G34-8 (E) Ignition switch ON 11 to 14 V
      G34-1 (IG) - G34-8 (E) Ignition switch off Below 1 V
      G34-8 (E) - Body ground Always Below 1 Ω

      If the result is not as specified, replace the transmission floor shift assembly.