VALVE BODY ASSEMBLY REMOVAL


  1. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  2. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

    A00K0C4

    1. Remove the transmission oil dipstick.

    2. Remove the 2 bolts and oil filler tube.

    3. Remove the O-ring from the oil filler tube.

  3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A00JWAQ

    1. Remove the 19 bolts.

    2. A00JUKVE04

      Insert oil pan seal cutter between the transmission case and oil pan. Cut through the seal and remove the oil pan.

      Note


      • Be careful not to damage the oil pan flange.

      • Some fluid will remain in the oil pan. Carefully remove the oil pan.

    3. Examine the particles in the oil pan.


      1. Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to determine the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

    A00JVLWE02

    1. Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the 3 gaskets from the oil strainer.

  5. DISCONNECT TRANSMISSION WIRE

    A00JWTE

    1. Remove the bolt and temperature sensor clamp, and disconnect the temperature sensor.

    2. Disconnect the 4 connectors from the 4 shift solenoid valves.

  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

    A0098QBE01

    1. Remove the 20 bolts and valve body.