CRUISE CONTROL MAIN SWITCH INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL CRUISE CONTROL MAIN SWITCH


    1. A009ADI

      Install the switch with the 2 screws.

    2. Connect the connector.

  2. INSTALL STEERING PAD


    1. A009AGR

      Support the steering pad with one hand.

    2. Connect the 2 connectors to the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.

    5. Using a T30 "TORX" socket wrench, tighten the 2 screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A0095EBE01
      Text in Illustration
      *A w/o Cruise Control System
      *B w/ Cruise Control System

      Attach the 2 claws to install the cover.

  4. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. Attach the 2 claws to install the cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.